LED PROJECTOR FOR CHRISTMAS HOUSE WAVES + 12 SLIDES

SPECIFICATION

INCLUDED:

EASY TO USE

The projector is ready to use right out of the box. Just plug it into the socket and immediately enjoy the sensational decoration. To facilitate the installation of the device, a pin has been included in the set, which is enough to attach to the projector with a screw and hammer into the ground.

To replace the cartridge:

1. Loosen and remove the two screws

2. Lift the cap with the seal, you will see a cassette with a slide inside

3. Pull out the cartridge, being careful not to touch the pictures on the slide

4. Insert a new slide of your choice

5. Reinsert the nut with the gasket and tighten the screws.

Place the projector about 3-4 meters away from the projection surface. After the lights are turned off, it may be necessary to re-position the projector in order to obtain the best picture quality.

In accordance with COMMISSION REGULATION (EU) 2019/2020 OF OCTOBER 1, 2019 AND COMMISSION REGULATION (EU) 2021/341 of February 23, 2021 and COMMISSION DELEGATED REGULATION (EU) 2019/2015 OF MARCH 11, 2019. AND COMMISSION DELEGATED REGULATION (EU) 2021/340 of 17 December 2020 Art. 2 sec. 1 lit. a), this product does not fall within the definition of a light source. This product is exempted by regulation.